Search results

GrandDaddy Go Kart Plans - SpiderCarts You need to buy pro plans apparently to get grand daddy.

yuck. What do yall think of the Hyundai N-Vision 74?

I don't know. The Audi S1 Hoonitron is nutty; I feel like the possibilities of electric fun cars hasn't been fully explored. For the weight, Electric can deliver much more torque. Its the battery that's the issue. I think once we get a super light/ efficient/ cheap battery, a light electric car...

be awesome if it works

Hey, at least now the highschool varsity footballers in my area wont wake me up when they sneak out.

I think part of the problem is we're teaching what to think, not how to think. Look at how many warning labels are on tools these days, and compare it to an older tool. The sliding chopsaw I have from the 80's doesn't tell you "no brake" and "Keep you hands away from the blade", It just assumes...

I'm taking classes on DE next year. Any tips/tricks?

DONE! FINALLY! I cut the pillow block assembly off first with an angle grinder and cutoff disk. I ended up breaking the outer race away delicately (8 lbs sledge) then gracefully removing the bearings and container (sledge again) but had trouble with the delicate method of hammering away at the...

Was fitting new Sprocket hub. Axle bearing is stuck on axle. Any tips for removal? I removed the set screws and tried torching, liberal amounts of penetrating oil, WD-40, CV axlepuller, sledge hammer and cold chisel. Any other ideas? I about to setup a press.

If you don't have anything yet, you can buy old razor mx550 kids bikes of FB Marketplace and put them into small carts. That way you buy a working system, and don't have to cobble parts what do you mean by What RPMS are good?

Thank you!

I do. It's weird.

I found this for $15, is it a good deal? Pillow Block Assembly | 3013-2806 | BMI Karts and Parts

More info is better than less

Two Questions: 1) Is the right angle turn in the bung important? Or can I just flow the fuel straight down? 2) How did you find the bearings for so cheap? I'm looking at replacing one of mine (it stuck, but works with heat and WD-40) but cheapest I could find was this: SKF - 1-3/16" ID x 2.4409"...

I have a drill press and taps. Just drill a hole in the bottom and tap/screw a barbed nub in, then replace the original spray head with a vented cap?

Measured, wheel in total is 8 inches in diameter. I apologise, I don't know where I pulled 6 inches from (certainly wasn't out of my pants). I mounted the engine with a temporary gas tank (cup+tape) and used a 48 tooth pitbike sprocket and that seemed to work fine. Next up: Can yall please...

they are 6" Go kart racing slicks, 3 bolt pattern. I posted photos to the thread "How to transfer power sideways 3 inches?"

Pics of where the missing assembly attaches would help greatly in providing clues as to the shape of the assembly. YOU did that, based off of you being able to tell which of the four EZcomeEZgo posted would be most likely to fit. Just because you cant figure heads or tails doesn't mean someone...

Increase brake lever length? or use a booster?