Search results

thank you all for the advice. I put a model through AutoCad and realized my welds would need to be orders (3) off magnitude better to conduct the horsepower I want to throw at it. Im gonna go with the custom hub idea from Master Hack

I meant welding tabs on, then drilling holes and bolting the sprocket to the holes. I can control concentricity by changing where I drill the holes, and by not welding the sprocket, I don't warp it. I could then make the tabs identical to lessen the vibration from oscillation. Im using a 1 and...

I understand that the sprocket need to be concentric to the live axle on a kart. I previously posted this idea and was told it would not work because the sprocket would not be concentric. If I welded tabs to either side, then measured out the holes radial from the center of the axle, it should...

you could remove the solar panels during practice as well, or pass along a series of written instructions or the keys to the nobled2 account so that the person who comes after you has access to the questions you've asked

It seems like yall had two crashes due to unprepared drivers. Maybe a trainer course or practices?

couldn't I just throw an adjustable resistor to it and call it a day?

If Im converting DC to three phase AC, what inverter should I buy, or should I just make one?

If he is running a 3 phase AC 120v motor, what kind of inverter would he need?

Woah! Super neat! welcome!

yes. Clean the filters (Dawn dish soap and WARM not hot water works well for me) It's rough being new to this forum, but please do make an effort to use spell check. The added time of your right click left click saves these old grease-stained geezers grizzled veterans time Also make sure to...

Would an electric motor solve any of these problems? I could mount a motor to the cylinder bolts and run a chain to the clutch from there, then stick batteries and a controller above it.

Are there sister bikes for an older gen yz? Will a 95-yz80 rod fit a 86 yz-80 engine? If not, is there a site like Engine, Transmission, Chassis Swap Donor Vehicle Look-Up (roadkillcustoms.com) for donor bike lookup? probably cheaper to just get a new motor

Thank you all, I rekeyed the axle and mounted the engine, now to mount the sprocket to the axle.

If I can find a parts bike, maybe. I can press the bottom apart (I built a press) but to get the rod is a trick and a half.

Where would I get the Axle re-keyed?

Could you use ride-on lawnmower rear-differentials for the 6x6 rear? Like the one on the Craftsman Lt2000?

Maybe used dirtbike shocks? You can rebuild them pretty cheap with standard spacers and washers.

I am trying to replace a missing piston and connecting rod in a 80cc yz-80. However, I am poor and cannot afford the 300$ for a piston and connecting rod from Wossner Yamaha YZ80 1985-1987 – WOSSNER NA (wossnerpistons.com). Any tips on doing it cheaper? Should I just replace the engine? Or buy a...

sure, my camera is broken so these are ss within cam app I plan to run a four bar linkage forward to preserve the shift function.

gold bullion, not steak. But ill send the pennies over shortly. I just need your full mailing address, full zip code, the last four digits of your social security number, and for you to fill out this survey: https://tinyurl.com/survey98310