Functional Artist
Well-known member
I used CAD to fab up a lower windshield/back of the dash panel
Another view
Then, probably trim the ends off, to follow the contours of the dash
Used the CAD template to transfer the pattern, to some 18g. steel
Kinda like this
Then, cut 'er out
Then, did some bendin'
Had to get creative with the clamping, for some of the bends
...& the ends too
It turned out lookin' like this
Another view
Then, probably trim the ends off, to follow the contours of the dash
Used the CAD template to transfer the pattern, to some 18g. steel
Kinda like this
Then, cut 'er out
Then, did some bendin'
Had to get creative with the clamping, for some of the bends
...& the ends too
It turned out lookin' like this