Search results

its my birthday tomorrow, and i have decided i want a welder. does the 90 amp flux from harbor work good? i looked into the 110 amp MIG & flux, but then i researched how much a CO2 tank would cost. to much. so i think i want to stay with flux. does the 90 amp work well? im not going to be...

what is the shortest double flange hub i can get? i hadea3 inch and the cut it to make it shorter but i don't think i cut it perfectly straight, so i keep on breaking bearings. so which website has the shortest wheel hub i can buy.

i was thinking, how expensive would it be to switch to live axle? the set up i have now is a *****, since there must be a spacer from the sprocket to the hub, it makes it difficult to get everything lined up, and now i continue to break bearing after bearing. i have a friend that would gladly...

on my clutch every single tooth was like grinded down to nothing. the reason this happened was the wheel keeps on slipping off the axle. we tried a lock washer and any nylock nut and nothing works. what would work better, to tac the bolt in place, or drill a hole through and put a cotter pin...

on my clutch every single tooth was like grinded down to nothing. is it possible to buy just the cover instead of the whole centrifugal clutch? the reason this happened was the wheel keeps on slipping off the axle. we tried a lock washer and any nylock nut and nothing works. what would work...

What are the best and cheapest ways to get more performance out of my 6.0 hp Tecumseh engine? I have already taken of the governor.

is the speed calculator accurate? right now, my tires are 13 inches my axle is a 60 tooth, and my clutch is a 12 tooth. i wasn't sure about what my engine was rated for in RPM's but i know it can do around 35 MPH so i filled in the blanks. i knew everything but RPM's so i just typed in randoms...

can any of the following be used to clean a carb? my carb cleaner has "gone missing" PB blaster starter fluid WD-40 engine degrease [im guessing no]

i got a 5hp B&S engine with my go kart when i bought it. the man who i bought it from said it is a high compression engine. but im not really sure if it is, or if it even runs. would it hurt the engine if i tested it to see if it ran , with regular gas?

i might be wrong but form looking at posts form other people on a bunch of sites, it sounds like my kart shouldn't be able to go 35MPH. the engine is just a 6HP Tecumseh, 12 tooth centrifugal clutch, 60 tooth axle sprocket. should it be able to go this fast? also are there go kart drag races...

i bought a go kart recently, and not thinking i just assumed it was a 2 stroke. i was wrong, i looked up the engine online, and it is a 4 stroke. i only put in like 6 or 7 Oz. if i just fill the rest up with 4 stroke oil would it be ok? i cannot get this **** drain plug off, so that is why i...

my friend and i 15 and are planning on building a go kart out of my 1987 Yamaha srv snowmobile. has anyone here done this before? is it to hard for people our age? i have been planning for a couple days and i think i have most stuff planned out. but im still not sure on some things. i plan on...