Search results

mini chopper and im putting a jackshaft on it would it be better to put the clutch on the engine or the jackshaft or would it not matter?

could i put a c02 kit on my hf clone, or would it be to hard on it?

i took a run of the mill electric blower, took off the motor, put a pulley on it. still got a little work to do but its almost done :useless:

i found a 31cc RYOBE weedeater not vary big but if i can get it at 1000rpm with me on it the speed calculatar sais that is will go 9mph

weld 1/4'' mild steel? http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=54878

does any body know any good gokart and mini bike stores?

simple, easy and cheap ways that i can make my engine have more power and more speed?

could i put a octane boost in the fuel of my stok tecumseh 4hp?

can i put a gear box from a dirt bike/4wheeler on my tecumseh engine if the cam is the rite size?

i found this realy cheap 2 cycle 4hp 3600rpm tecumseh but it has a steped shaft, and i dont know if i can get a 5/8 inch clutch on here because there is only .9 inches of 5/8 shaft here are the specs 0.6688" dia. x 1-1/2" 5/8" dia x 0.9" any body got some suggestions?

does any body know a good go cart parts store that you have bought from?

how do i know if im getting ripped off or not on ebay?

well im making the brackets on the back of my mini chopper that the axle will go through, im using 1/4'' weldable steel and dont know how to get a 3/4'' hole in it without having to go buy a $35 3/4'' drill bit

how did you get the pipes cut so that it welds nicely to the tubing

i found a jackshaft on this website BMIkarts.com and found a jack shaft with two diff. gears on it i have two questions about it 1st. has any body ever shopped at this place 2nd. how does the two gear'd jackshaft switch gears?

Should i use a jack shaft on my 6 hp mini chopper?

i need a way to get the circle cut out at the top where the forks atach

Can any one tell me the angles for the mini chopper on this site?