When you install the wrist pin clips make sure the the open ends face either 6 o'clock or 12 o'clock in relation to the crown of the piston, get used to doing this because believe it or not open end wrist pin clips depending on their outward spring tension can compress at high RPM and come out if the open ends are facing 3 or 9 o'clock when the piston changes directions at T.D.C and B.D.C. That is a reason that they make spirolox wrist pin clips and teflon wrist pin buttons to use in place of open end clips, I am not saying that your engine is going to turn enough RPM for this to happen but as an engine builder I am saying just get used to phasing open end wrist pin clips this way because it has happened and can happen.
---------- Post added at 06:44 AM ---------- Previous post was at 06:19 AM ----------
Another little tip that I might add is when an engine uses bearing shells I always clean the back sides of the bearing shells and their contacting surfaces with acetone in order to remove any oil or grease that gets on them from handling them, any oil or grease left in the back sides of the bearing shells becomes a heat transfer insulator between these surfaces and does not help the heat that is induced transfer away from the bearing shells, it is best that the heat that is in the bearing move outward away from the bearing into the bearing mounting material, connecting rod, block, etc.