Search results

Could you thread a nut on the stud then weld it to the stud. Then you can use penetrating oil and a wrench to take it out.

http://home.gwi.net/~spectrum/snowgallery.html These are some gilson snowblowers that look similar to yours

I had a honda gx 120 with a short crank shaft that was 3/4" stepped down to 5/8" which was threaded. It was to around an inch to short so i drilled and tapped the crank to 3/8" threads and took a peice of 3/4" roundstock with a 3/8" bore and bolted it to the end of the crank. Then i put the...

Steel wool works good too, and it doesnt scratch the aluminum engine that much like a wire brush does sometimes.

I dont know if it would remove paint but you could make a cheap soda blaster. http://www.aircooledtech.com/tools-on-the-cheap/soda_blaster/

Theres an low speed idle jet just below the throttle butterfly that may need cleaning. Its under a little Black plug. Look at picture 9-12. http://outdoorpowerinfo.com/repairs/honda_carb_16100-ZF6-W10.asp

I didnt really like 4.5 cut off discs i got from Harbour Freight. They didnt last to long for me.

My last day is the 23rd...

I looked all over the engine and those were the only numbers i could find.

On the shroud it says 6b-hs 900299 5805150. I just want to find the year and the hp rating.

Ive only seen one horizontal in the garbage but i do see alot of weed wackers and chainsaws.

If I remove my governor from my 6.5 hp clone, is it necessary to re-jet the carb? Or can i still use the stock jet.

I just got my clone today too. $72 with the 20% coupon.

I tried the sand tip for my mini bike frame yesterday and the bends were great. The only bad thing is that there are two little bumps from the rollers on each tangent. Thanks for all the tips guys.

Nice tutorial.

Ok, Ill try the sand trick then. I just thought of the ice thing because ive seen it on a tv show when they were making musical instruments.

Go canada!!!

I just bought a Harbour freight 12 ton pipe bender for 74 bucks when i went to NY for skiing. :wai: Does anyone have any tips on bending pipe. I heard about packing it with sand. What about filling it with water and keeping it overnight to freeze. Would that be even better than sand?

Looks really fun! Nice trails btw..

I think there are two spring loaded metal arms that are supposed to go in those threaded hols. Like in this picture https://www.kartsandparts.ca/store/images/T/078-02.JPG