Search results

Thanks! i am going to try and find one. Also just found out that these newer honda's have a REV limiter built into the coil. Looks like i need to buy something else now... this unfortunately will cause a delay in getting the better TC and flywheel. Is what it is tho.

Reaching out for some advise. Finally got every put together, to include the new carb. It idles good, rips off the line but i expected more from it. I settled on a 40 series TC while i save funds for a duster. Issue: 1) i feel as if the engine is not turning more than stock RPMs( No tach to...

Thanks!

Any recommendations on where to buy either one ? Somewhere not over priced

Getting done with the gx390 build, mild cam, crank, heavier valve springs, longer rod, slightly shorter piston (sits .05 below) , thin head gasket, ported intake and exhaust. Still waiting to buy a 34mm carb but with no Dino I’m still assuming this will make more than 22hp and looking for...

Any opinions on this TQ? https://www.bulletlines.com/40-Series-Torque-Converter-Kit-p/62.htm

Trying to get pictures up.

Not sure how to add pictures on this site

I have a almost brand new gx390 off a generator. Started the build already, new crack, mild cam, billet rob, stiffer valve springs, governor deleted. when I realized the carb has the electric solenoid. Is this going to cause me issues? if so are there any work arounds? Can I just remove and...

Managed to pop a belt due to alignment issues a. I fixed the issue now I’m searching for a heavier duty belt if possible. They belt I had was 27”x 3/4” I believe. Center of drive shafts measure 6 5/8”. Does anybody know if there is a heavy duty or super duty belt that would be compatible with...

Ended up putting a 60 tooth sprocket on the axle with 10 on the TC and 18” wheels. With the app I got a max of 41 with a 39 average in mph. Over all I say for 300 bucks and about 50 man hours of work a little blood and a lot of sweat this little project came out very good.

I got the comet 40 series torque converter off of amazon for around 73 bucks. I have it on a 13hp Honda clone . I had to make a smaller spacer (about 3/16”) but I’m sure you’d be able to find a washer with a 1” hole at any good hardware store.

Made a spacer and everything is GTG! Will try that app out once the wife returns. I have downloaded it but can’t go full speed with the youngsters and can’t leave them home unattended. Will try and get a screen shot once I do. Thanks everyone for the advise and help and input!

Not sure how to find the ap, lol. What's the name of it?

Got everything hooked up and took it for a drive, runs good but guessing I have a mis alignment because my belt flipped over when I went wide open. Will add a spacer tomorrow and see if it fixes it. Side note, I feel as if she got over 40 mph but I have no real way to test the actual speed.

They were 20x11-8, new ones are 18x8.5-8. Went from heavy nobbies to street treads. The torque converter I ordered is coming with an 10 t #40 sprocket .

Good news, torque converter kit is coming tomorrow. I got my new carb, chain and air intake today. Built a custom exhaust and got it painted with high temp rust o lem. Also put on so 18" wheels. We shall see how she runs tomorrow. Thanks everyone for the help and advise!

Can't figure out how to post a video but it does sound so good!

Thanks everyone, got the new carb today and she is running like a new!

Ended up going with the torque converter, should be here by the 15th. Will let everyone know how it goes.