Search results

Spring tensioner, like what is already found on a riding mower, going to be a little tricky rigging it but thats the only one I could think of, also I cant shift when moving since the axle is directly connected to the tranny and the tranny can't be spinning.

I'm building a go kart with a riding mower engine in it. I have a 5 speed tranny and I need help coming up with a clutch to keep it from moving when I start it.

I know it steps down

the wheels are 3/4 because the trans on the lawnmower had a 3/4 axle all the way, no step down, and that axle is way too short, im getting this axle http://www.mfgsupply.com/m/c/AZ1401-44.html?id=nZefQDh7 and that will barely fit, and i dont think the wheels have hubs, just a solid wheel but i...

hey guys, I have a problem, I was going to use the back wheels and tires from a ridingmower, but the wheels fit on a 3/4axle and i was planning on using a 1in axle. The tires are 20x8x8 and i was wondering if i could use these wheels for them http://www.mfgsupply.com/m/c/AZ1005.html if i cant...

Which would be better, 5in ODx .095in wall or .625in ODx .065 wall or .12 wall ( they are steel DOM tube)

oo thats nice, thanks!

ok i found a 21x9-8 and im assuming those would work on the wheels i listed, but do i need tubes even though they say tubeless? i mean, isnt that what keeps the tire inflated? Do the tubes have to be the same size as the tire? i have only found 18x850/950-8 and 22x1100-8

hey guys im a little confused on getting the wheels and tires to match, if i get a 8"wheel 9"wide, does that mean any of these can work? http://www.mfgsupply.com/ATVTires8.html/mv_session_id=BVYo8my3 or does the tire have to be 22x9x8 ,20x9x8?

o, ok, i didnt know it was that simple, and im planning on doing a live axle and some setup like ryf, but are those the stock belts on ryf's? because they seem a bit shorter than the stock ones

so the clutch is when the belt comes off onto an idler pulley?

ok, because i heard that the gearbox wasnt very strong, but im guessing thats when you use just that and put wheels on it.

Hey, i was wondering if i could use the lawnmowers gearbox and put sprockets on the gearboxs shaft and have the sprockets on the shaft attached with a chain to a sprocket on the drive axle, would it hold up?

ya i guess, but i never really seen trailer leaf spring suspension, im thinking j big tires because i never have done this before

ya, but ill do alot of tooling and try not as much spending lol, also i dont want single wheel drive i want the axle spinning and both wheels

also, are wheel hubs without bearings and a keyshaft for mounting the wheels to the axle so the wheel spins?

i thought differental axles werent good for off road

ok, i didnt no if soft tires would be good suspension, but i been redesigning and thinking mayb 4wheels in back for more speed and less weight and shorter length

yes and vertical

also, with the suspension, how will the axle and wheels come up without pulling on the chain? i mean the axle doesnt go straight up it goes up and back a little