tires and wheels

[18HPHalftrack]

hey guys, I have a problem, I was going to use the back wheels and tires from a ridingmower, but the wheels fit on a 3/4axle and i was planning on using a 1in axle. The tires are 20x8x8 and i was wondering if i could use these wheels for them http://www.mfgsupply.com/m/c/AZ1005.html
if i cant, should i just buy new wheels and tires or do you guys have any other ideas?

 

[RobertD]

The wheels are 3/4? You might call to confirm, but this axle says that it's 3/4. What do the hubs look like? Is it a 1" to 3/4" step down, or how did they mout to the other axle? Pics would be a plus if you can get them.

Dont' forget on those wheels you posted you still need to buy the hubs for them.

 

[18HPHalftrack]

the wheels are 3/4 because the trans on the lawnmower had a 3/4 axle all the way, no step down, and that axle is way too short, im getting this axle http://www.mfgsupply.com/m/c/AZ1401-44.html?id=nZefQDh7 and that will barely fit, and i dont think the wheels have hubs, just a solid wheel but i would have to check

 

[2or3wheels]

the rims your linked up are for a 4 bolt hub pattern, not an axle unit.

 

[2or3wheels]

That axle doe step down to 3/4 inch, look at the demention pic toward the bottom left.

 

[18HPHalftrack]

I know it steps down

 

[2or3wheels]

so you want 1 inch for your tires?