predator 212 start problem
- Thread starter Culljeff
- Start date
Whitetrashrocker
Inmate #952016
Did you align the cam and crank timing marks?
Did a lifter fall out during install?
Is the valve lash set properly?
Does the flywheel have a key? Is it aligned properly?
Coil gapped properly?
Spark plug wire on?
Gas in the tank?
Gas in the bowl?
Switch turned on?
Did a lifter fall out during install?
Is the valve lash set properly?
Does the flywheel have a key? Is it aligned properly?
Coil gapped properly?
Spark plug wire on?
Gas in the tank?
Gas in the bowl?
Switch turned on?
Denny
Canned Monster
Lash cap on?
karl
Well-known member
Does it have a fuel pump? Bowl might be dry, does it hit on starting fluid, ect?
Edwin Spangler
Well-known member
- Messages
- 981
- Reaction score
- 970
ezcome-ezgo
G'me sumthin to write on
So remove the parts that make it run, add new parts, now it doesn't run. If it was me I would put the old parts back on and see if I could get it to run. It might be edu-ma-cational.
panchothedog
Well-known member
- Messages
- 2,883
- Reaction score
- 3,898
The guy hasn't been back since an hour after his post. Might be another one of those.
Whitetrashrocker
Inmate #952016
Imagine this gen using a card catalog and writing down numerous notes, then having to use the DD system and find a book in a building full of books to find any info your looking for.
Or buying a magazine and waiting a whole month for the next edition to come out so you can read part 2 of how to....
Or buying a magazine and waiting a whole month for the next edition to come out so you can read part 2 of how to....
I'm gonna take everything back apart today thank you!!
I might try this think its the cam?? we'll see i'll report back
I've been working on it chill
Lo206
I didn't think it needed them I didn't put rockers on it yet...?? Am I wrong?
Denny
Canned Monster
There’s usually one on the exhaust valve from the factory.