Recent content by Devonakaozzy

theres 3 holes on this driven for the spring, I understand it is for adjustment, and I have read a little about it, but it is still unclear to me. The spring is in the middle currently. Now, putting the spring in the "Low" hole would do what? increase time in low gear? and putting in high for...

I'm getting a 1985 110cc Honda 3wheeler for parts. I plan to use the engine on a go kart, however it is missing the recoil start, does anyone know of any place to get the recoil start for one?

https://vine.co/v/bY71TwIWhjP That was me testing it out, pretty fun when its wet. https://vine.co/v/bY75V5Zxurz And this was my friend kicking up water and spinning out This is what we do in our metals class when we find a go kart, few weeks of fixing then about a week of "tuning"

the switch is just under the steering wheel I mean, and it is easily accessed. It was wet out today but ill have a video of my friends and I goofing off on it here in a little while! next up is moving steering to the middle and gas over to the left, theres plenty of room for me now, I just don't...

and then switch hubs if id like to switch from 1wd to 2wd, but I pulled the hub off and it has no keyway, just threaded for a nut at the end

So this is what I scored for 100$ the other day. At first, this is what I got (Pic1). The motor was just sitting on the frame, nothing was hooked up or bolted down. The motor came with a 20 series driver clutch (oh goodie!), but no driven or belt. I took that off and put it away for future use...

okay, so I now learned it is in fact a lighting coil. the red wire is DC+ current at 3 amps and the yellow is AC current at 5 amps. how do I wire two lights on the front of my kart? ill be using a pair of led lights that only draw 1.25 amps at 12v

no, the kill switch wire is located on the front by the recoil start, it also has a green wire that runs down with a connector to wire a remote killswitch which was already installed on the cart. also, I don't see any matching connectors, or any spot on the block for an oil sensor, so I do think...

hello all! I got my kart going with a centrifugal clutch and in the process I noticed two wires. I did a little research and found that they are live wires. now, I want to put lights on the front of my kart to see at night while riding. how would I go about doing this? I would like to have a...

so with my kart I recently got came a 6hp Tecumseh power sport engine. the linkage is from gov to throttle is missing. should I replace or fab up a linkage or just bypass it altogether for now? I wont get too crazy with the throttle if I bypass it..

I have enough clearance, since this kart has a live axle but is disable by a bearing in a hub on the pass. side, I decided im going to weld it on there since I have an extra 1" axle laying around:rolleyes:

okay, she left her lights on at the good ol walmart the other day and her friend attempted to jump her car. key word here, attempted. in the process she put the positive on the negative and vice versa on her car, but matched the terminals on the car with the good battery. now the thing is, we...

i have a 72 tooth sprocket and the clutch im getting has 10 teeth for a gear ratio of 7.2:1 if im not mistaken the tires are nearly the same size of the sprocket

i have looked a little but it would be symmetrical, both sides are the same, as of now i only have the driver so i might just put that away for now and grab a normal centrifugal clutch until i can order the driven a belt and a jackshaft kit.

id say the straight is about 150-200ft long or so