Hi,
I currently have a go kart that i build my self and it has a couple issues. The main one being the clutch to axle system. I have a predator 212cc with a jet'd carb and an exaust, but the problem is that i burn through clutches within a week of good riding. The teeth of the clutch actually get sheered off, and im not sure why this is happening. Anyone have any ideas?
---------- Post added at 07:03 PM ---------- Previous post was at 07:02 PM ----------
I was thinking about getting a torque converter, but the space between my drive shaft and my axle is not enough to fit anything more than just a clutch.
I currently have a go kart that i build my self and it has a couple issues. The main one being the clutch to axle system. I have a predator 212cc with a jet'd carb and an exaust, but the problem is that i burn through clutches within a week of good riding. The teeth of the clutch actually get sheered off, and im not sure why this is happening. Anyone have any ideas?
---------- Post added at 07:03 PM ---------- Previous post was at 07:02 PM ----------
I was thinking about getting a torque converter, but the space between my drive shaft and my axle is not enough to fit anything more than just a clutch.