Thinking of rebuilding...

Status
Not open for further replies.

jr dragster T

New member
Messages
3,966
Reaction score
10
Location
Cold place
Lol, Your porting a wire brushing makes me cringe. If you want to build a real engine AND set everything to proper specs, Total dissasmbly is a must. BTW your not lapping the valves properly with the tappets still inplace. Old valves sink into the head and therefore have very little valve lash. To port properly you have to get in around the valve guide and 1/16" or closer to the bottom of the valve seat. Porting isnt a quick 10 minute half butt job. Do it right do it once and you will be impressed. Hope that helps. BTW most valve lapping compounds are oil based and you thin with oil:)
 

brendonv

New member
Messages
861
Reaction score
3
Location
Australia, Perth
I may not have ported it well but i can tell u it was better than before. Getting rid of all that carbon and stuff from the ports and stuff seemed to help.
In the intake on the right is like sort of bulb of metal. Is that suppose to be there? I might shave the eyebrows more but i think ill leave the porting for now, i dont want to screw it up.
 

Carlman

New member
Messages
162
Reaction score
1
My mate got one like that, it lasted 2 weeks mate.

My dremel 300 came with tonnes of attachments.
 

brendonv

New member
Messages
861
Reaction score
3
Location
Australia, Perth
My mate got one like that, it lasted 2 weeks mate.

My dremel 300 came with tonnes of attachments.

Yer its real ****. Lol, o well. Ill use it for my rc stuff now and get a good dremel 300 and be done with it once i get a job. Then ill port it out properly and shave the eyebrows. Im rebuilding my 3 horse atm so i might put that on the kart once im done.
 
Status
Not open for further replies.
Top