Offroad big block buggy

[Master Hack]

Thanks. I'm getting ideas together for same area on my junk.

 

[Eztrail]

Well after some sipherin, I chopped off the rear bars. Will be able to shorten the bottom bars some. Tacked in some supports and plate that the spool will mount to.

 

[Eztrail]

The mounting tabs that came with the JD's garage spool are too short for how I'm mounting it on a flat surface. I made 2 new brackets 1-1/2" taller and set the spool in place. Tomorrow I hope to check everything for level and tack it in place.

 

[Denny]

If it’s not level, just tilt your head a little.

 

[Eztrail]

Ok so I was able to get out in the garage today for a little bit. Bent up a rear bar and got the top joint mostly fitted. A little more tweaking and it'll be ready to tack in.

 

[Eztrail]

Weather is about to turn cold, hope to get out a little this weekend and make some progress

 

[Eztrail]

Was able to get out in the garage for a few minutes. I was able to finish cutting and tack in the driver side rear bar. Spool sitting in there not tacked in.

 

[Grizzlymi]

Awesome work with the tubing man! Can't wait to see that motor mocked up in there.

 

[Eztrail]

Thank you! I can't wait either!!!