New here need help

Status
Not open for further replies.

JBkartman

New member
Messages
29
Reaction score
0
Here's some pics

These are updated pics. The belt could be the next step smaller because it takes a second for it to catch and top speed could be better with one, but its temporary. Going tomorrow to take it to the shop to weld a few reinforcements and some support to the frame. Also debating weather to link up the other gas tank. Thanks everyone that helped me out on this could not of done it without ya :wai::surrender:
 

Attachments

  • IMAG1191.jpg
    IMAG1191.jpg
    112.2 KB · Views: 10
  • IMAG1193.jpg
    IMAG1193.jpg
    161.7 KB · Views: 7
  • IMAG1194.jpg
    IMAG1194.jpg
    155.6 KB · Views: 6
  • IMAG1195.jpg
    IMAG1195.jpg
    132.8 KB · Views: 11

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
Looking at the last pic you have there, it looks like the weight of the rier is going to bend the frame into the ground. To me it just looks too long, and that it is sagging in the middle
 

JBkartman

New member
Messages
29
Reaction score
0
The frame is lower to the ground in the front and goes up in the back..... As u can see the added frame going up in the back on a angle.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
The frame is lower to the ground in the front and goes up in the back..... As u can see the added frame going up in the back on a angle.

I was just worried that if you hit a hard bump, you would bend it in the middle. You are the best one to know your karts stengths, so if you are happy with it, then thats all good
 
Status
Not open for further replies.
Top