New here need help

Status
Not open for further replies.

TheWingnut

New member
Messages
114
Reaction score
0
Location
Del Rio, TX
For an engine of that size, a series 40 comet torque converter should do it. those are used for 8-18hp engines and 420cc is about that range.

Anf if your will to give away 150 bucks, they do enhance your engnes torque nicely and you dont have to make your own jackshaft because it comes with a plate that attaches to the holes around your engine shaft and has a shaft for the driven gear attached to it.
 

JBkartman

New member
Messages
29
Reaction score
0
can you please send me a link to buy the comet 40 serious with the jack shaft attached because I have not seen one
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA

TheWingnut

New member
Messages
114
Reaction score
0
Location
Del Rio, TX

mysteryboy28

New member
Messages
1,582
Reaction score
11
Location
Lansing, MI
The TC2 is misleading by claiming 8 to 13hp. it's just a Comet 30 knock-off, nowhere near as beefy as the Comet 40. Should be rated at up to 8hp, not 8 to 13hp.
 

TheWingnut

New member
Messages
114
Reaction score
0
Location
Del Rio, TX
Well there are some from 8-13hp and some fro 3-8hp. i think the 41 is acually for the 8-13 i may have been wrong im not entirely sure.

All i am saying is that a kit would be better because you dont have to make your own jackshaft, and it wont take up as much room.
 

mysteryboy28

New member
Messages
1,582
Reaction score
11
Location
Lansing, MI
i have the 390cc motor, and the Comet 30/TAV2/TL2 is NOT beefy enough. i wear out belts constantly, and it just isn't as good as a Comet 40. period. jackshafts are actually really easy to make. couple of pillow block bearings, a 5/8" or 3/4" shaft with 3/16" keyway, couple of sprockets, couple of locking rings with grub screws (i didn't use any, tapped my 3/16" keys in place and tack welded them to stay put. lol)... done.
 

Attachments

  • jackshaft.jpg
    jackshaft.jpg
    104.3 KB · Views: 14
  • jackshaft 2.jpg
    jackshaft 2.jpg
    92.9 KB · Views: 15

mysteryboy28

New member
Messages
1,582
Reaction score
11
Location
Lansing, MI
you will be very disappointed in the performance and durability of the Comet 30/TAV2/TL2 vs the Comet 40 with that motor. those lesser torque converters perform well with 8hp and lower motors.
 

TheWingnut

New member
Messages
114
Reaction score
0
Location
Del Rio, TX
Well a comet 30 is meant for lower hp engines, so its not going to work very well on a 420cc engine. I think we are on the same page but wording it differently.
 

TheWingnut

New member
Messages
114
Reaction score
0
Location
Del Rio, TX
you will be very disappointed in the performance and durability of the Comet 30/TAV2/TL2 vs the Comet 40 with that motor. those lesser torque converters perform well with 8hp and lower motors.

Yes. A comet 30 is meant for less hp engines and is not good enough. I think we are ont he sme page but not realizing it...
 
Status
Not open for further replies.
Top