H.F 11hp gov. removal
- Thread starter Mzguns
- Start date
- Status
Russ2251
AZUSA:Powered by LAWN-BOY
"Hard" is a relative term.
r97
Measure twice cut once
take bolts out, cut wires, solder longer pieces of wire in, shrink wrap, bolt in desired location.
Bluethunder3320
New member
- Messages
- 5,677
- Reaction score
- 36
r97
Measure twice cut once
like 1hr (max) of work, not a big deal, prob about as much work as it is to install a new light fixture.
devino246
Official DIYGK Chem Nerd
Arent 25% and 1/4 the same thing???
Bluethunder3320
New member
- Messages
- 5,677
- Reaction score
- 36
hahahaha lol, nevermind i say 25.01%
You're a quick one! I wanted to see if it would sway the OP at all. "25% isn't bad but 1/4...that's too tough!"
r97
Measure twice cut once
i have tried, lol. you can change the title by clicking the "edit" button on your FIRST post of this thread, then "go advanced", then just simply place your cursor in the "title" box and type in what you want.
jr dragster T
New member
Its 3 wires. 1 Positive to the switch from the positive in on the hot side of the starter solenoid. 2 is Positive trigger to the solenoid when key is turned to start. 3rd wire is from the ignition coil. Not a hard job at all.
r97
Measure twice cut once
i recall it being 5 wires, maybe i'm too tired. lol. you could prob set it up with 3 though.
i think this is pretty standard, wiring (please note you only need to extend the 4 wires on the key switch(big circle thing), then ground to the frame),
i think this is pretty standard, wiring (please note you only need to extend the 4 wires on the key switch(big circle thing), then ground to the frame),
Bluethunder3320
New member
- Messages
- 5,677
- Reaction score
- 36
wait i thought solenoids have 2 command wires
- Status