minichopperfreak
New member
can i use 6.5hp parts on a 8hp i would to use a honda gx305 aluminum fly wheel would it work?
can i use 6.5hp parts
- Thread starter minichopperfreak
- Start date
- Status
Doc Sprocket
*********
Man, I've never even heard of a Honda GX305.
KartFab
Active member
Gx160 and gx200 have SOME interchangeable parts. Not sure about the higher hp ones.
r_chez_08
Should be in the shop...
Doubt it mate, 6.5 and 8hp are different block sizes and like a different series of parts as far as I know.
Gx305???
The only reliable oem aluminium flywheel that you can get for a gx160/200 is one from a gxv160 (possibly other gxv) flywheel brake model. Believe me, I researched for way too long, trying to save a buck or two, and these gxv160 ones are rarer than rocking horse dump, except on karting sites
Gx305???
The only reliable oem aluminium flywheel that you can get for a gx160/200 is one from a gxv160 (possibly other gxv) flywheel brake model. Believe me, I researched for way too long, trying to save a buck or two, and these gxv160 ones are rarer than rocking horse dump, except on karting sites
Doc Sprocket
*********
, and informative, too.
exenos
Project Nut
Care to enlighten me? I'm imagining a pile of crap in a rocking chair here.
Doc Sprocket
*********
Can a rocking horse take a dump? Not likely. Therefore, pretty rare.
exenos
Project Nut
Ahhh, read it the wrong way. Makes much more sense now.
mckutzy
Well-known member
Ok clearly it was a typo.
OP-I reckon you are just going to end up buying the upgrade parts you want to get.
Im thinking in this case there is just no easy way around it. We talked on the other thread about machining a flywheel, next time come off hand what you want and for what.
OP-I reckon you are just going to end up buying the upgrade parts you want to get.
Im thinking in this case there is just no easy way around it. We talked on the other thread about machining a flywheel, next time come off hand what you want and for what.
r_chez_08
Should be in the shop...
Waste of time imo if aftermarket parts are available. Getting the taper perfect, getting the balance perfect, getting timing perfect and finding the right magnet would take a while, and then look at the cost for a massive chunk of aluminium, or even steel. Not cheap!
Cheers,
Rob
mckutzy
Well-known member
That's what was explained there, it isn't worth it.
Doc Sprocket
*********
r_chez_08
Should be in the shop...
Mate, not being funny, I don't have a clue what you are trying to get across! If English is not your first language, then I apologise, but if not, please make more of an effort.
Food for thought.
Cheers,
Rob
He is from Pakistan, but I agree that he should use better english.
Mafi888, what you can do is use google translator to translate from Urdu? to english and then paste it here
robbie
New member
The sad thing is that he probably already used the translator.
- Status