bob58o
SuckSqueezeBangBlow
To make a leak down tester or to not make a leak down tester?
Test 125 psi from the chamber side. Test the valves and the rings.
LOL
That is the question.
---------- Post added at 02:11 PM ---------- Previous post was at 02:04 PM ----------
How to convert HF Compression Tester into primative leak down tester.
https://www.youtube.com/watch?v=fmavwDldl8M
---------- Post added at 02:15 PM ---------- Previous post was at 02:11 PM ----------
Does this make any sense? Or am I still way off. Do I get to keep my man card?
I feel the leak down tester is the GAB way to go.
---------- Post added at 02:36 PM ---------- Previous post was at 02:15 PM ----------
At least with the 10.8 lb springs, The installed spring height is right around 0.850" with the stock valve and retainer.
The installed spring height with the SS valve and its retainer is ~0.800".
I tried to account for the difference in retainer thickness when measuring, but I don't think the 0.050" will cause a huge difference in seating pressure, nor do I think a small difference in seating pressure on each of the valves will do any harm?
The 26lb springs are the same length as the 10.8 lb springs.
---------- Post added at 03:08 PM ---------- Previous post was at 02:36 PM ----------
I feel like this is the appropriate style of music for lapping valves. OR KILLING VAMPIRES.
https://www.youtube.com/watch?v=pZs8VQ6LxsY&index=10&list=PLLm9h4_cqlM6LSePofHrngtzLhlxi6o_a
Test 125 psi from the chamber side. Test the valves and the rings.
LOL
That is the question.
---------- Post added at 02:11 PM ---------- Previous post was at 02:04 PM ----------
How to convert HF Compression Tester into primative leak down tester.
https://www.youtube.com/watch?v=fmavwDldl8M
---------- Post added at 02:15 PM ---------- Previous post was at 02:11 PM ----------
Does this make any sense? Or am I still way off. Do I get to keep my man card?
I feel the leak down tester is the GAB way to go.
---------- Post added at 02:36 PM ---------- Previous post was at 02:15 PM ----------
At least with the 10.8 lb springs, The installed spring height is right around 0.850" with the stock valve and retainer.
The installed spring height with the SS valve and its retainer is ~0.800".
I tried to account for the difference in retainer thickness when measuring, but I don't think the 0.050" will cause a huge difference in seating pressure, nor do I think a small difference in seating pressure on each of the valves will do any harm?
The 26lb springs are the same length as the 10.8 lb springs.
---------- Post added at 03:08 PM ---------- Previous post was at 02:36 PM ----------
I feel like this is the appropriate style of music for lapping valves. OR KILLING VAMPIRES.
https://www.youtube.com/watch?v=pZs8VQ6LxsY&index=10&list=PLLm9h4_cqlM6LSePofHrngtzLhlxi6o_a
