Quoted from the Briggs repair manual....
Check Compression
Briggs & Stratton does not publish any compression
pressures, as it is extremely difficult to obtain an
accurate reading without special equipment.
It has been determined through testing, a simple and
accurate indication of compression can be made as
follows:
Remove both spark plugs and insert a compression
gauge into either cylinder (one cylinder at a time). Turn
engine over with engine starter until there is no further
increase in pressure. Record this reading. Repeat
procedure on other cylinder and record that reading.
The difference between both cylinders should not
exceed 25%. More than 25% indicates loss of compression
in the cylinder with lower pressure. See example.
Example:
Cyl. #1 Cyl. #2 Diff. % Diff.
Eng. #1 65 PSI 60 PSI 5 PSI 7.6%
Eng. #2 75 PSI 55 PSI 20 PSI 26.7%
If compression is poor, look for –
1. Loose cylinder head bolts
2. Blown head gasket
3. Burned valves, valve seats and/or loose valve
seats
4. Insufficient tappet clearance
5. Warped cylinder head
6. Warped valve stems
7. Worn bore and/or rings
8. Broken connecting rods
Cylinder Leakdown Test
The cylinder leakdown tester, Tool # 19413, may be
used to test the sealing capability of the compression
components of each cylinder and quickly identify the
problem component.
Cylinder Balance Test
If the engine is hard starting, runs rough, misses or
lacks power, perform a cylinder balance test to
determine whether both cylinders are operating to their
full potential.