Search results

Sure look nylon to me.

I’m reading some reviews of these other clone engines an people are saying the Cam is made of plastic.

I’m debating. I’m hearing Temu is hit or miss with actual delivery. I’ve wasted more than 250 on stupider things 🤦🏼‍♂️

I’d think so if you only wanted 100.00.

Has anyone had experience with the Temu engines? They are just another from of a Honda clone, probably made from the same factory. The 420cc on there is selling for 240.00.

I’ve seen multiple karts that have two mounting points for the axle bearings, one for a lower ride and one for a higher ground clearance. You might be able to lower the axle a little without any swing arm modifications to allow a little more clearance. And to me, that last picture looks like the...

My wife gets mad when I smell like gas 😂

Luckily I didn’t have to reject, just some air mixture fiddling.

Just started on the first pull. It appears it just needed the carb adjusted to match the timing Advance.

I played with the carb adjustments today and it started on the second pull. I’ll go back and check it again when it cools off to see if it’s repeatable.

Yes I haven’t upgraded the rod. I’ll run it this way until it goes and I’ll put a 420 on it. Everything I’ve got can be swapped over to my kids go kart. I haven’t done the Governor delete for him yet.

I bought the dingo so the kids friends could come over and ride during the summer and to give me something to work on. I’m trying to sell it for what I’ve got into it. I had the same one when I was a teenager but dang don’t remember it being so small. If I were to keep it for myself I would have...

I’ll do just that, but here is what I did do: it is for a non-hemi, which I have, I did lap it and I set the air gap at .040. It’s just weird to me that once I get it start, having to give it a a little throttle while cranking it, then once it’s warm it starts every pull.

I needed something to pass the time with so I picked this up for 100.00. The motor was supposed to run but had sat for 8 months. Well it just need a new carb. Cranked up on the second pull. I did a complete rebuild total cost was just over 500.00. I know I could have saved a lot more if I had...

I have an Explorer and I had to replace the complete axle assembly. Someone in their infinite wisdom welded the wheel and brake hub to the axle. It wasn’t too bad, less than 200 for everything.

I’ll be honest, I’ll give removing the old wheels a shot, but when it’s apparent it’s suck, I just cut it all out and replace the whole setup.

No I had the carb on, tuned and running for about 3 months prior to the flywheel. The engine ran fine with all the modifications, expect the flywheel. The addition of the flywheel is where all the issues started. It ran like a top before I swapped flywheels

Like most people I’ve upgraded a Predator 212, Governor delete, new valve springs, Mikuni carb, and exhaust. While riding the engine will rev upwards of 6700rmp. I’ve had zero issues with this motor, but was worried about the stock flywheel coming apart and stabbing me in the back. I replaced...

Absolutely thank you! You went above and beyond for me. I’ve ordered the part and hopefully get them soon so I can get the kids Kart back up. The old mechanical brakes just didn’t cut it since they ride on the road. I’m hoping to get this thing to actually stop.