Search results

The cart goes by itself slowly. And where the belt fits in the driven. Not a v Groove bc one side is flat. ---------- Post added at 03:16 PM ---------- Previous post was at 02:51 PM ---------- Thanks the diagram helps some

I bought 6" driven off of Amazon but new belt rides up out of groove about 1/8th inch is it supposed to. It keeps creeping

Yes it's only 35

Yeah a tecumseh 6.5

That's what I was asking was what the average kart does. I know my kids will do 45 mph on the street and I added after market air filter and jet and changed sprocket, clutch and chain from 35 to 41. Sprocket is smaller than it was and clutch has less teeth. I was just wondering if this is...

Propane and I was able to get bearings off with out too much trouble they spin good so if they are trash I'll change them later.

Can anyone tell me what series this convertor is and how to measure for a belt. It came off of a 2006 Brister's Scorpion ZX265 Go Kart. All I'm changing is the engine. It had a 6.5 tecumseh and I'm putting a predator on it. I'm cleaning rust off now.

The tube spacer spins freely between them, but they are locked on. I'm going to leave themy and try to move motor mounting plate to better suit my engine. I have oiled beat and heat for weeks after work and nothing. I did save stainless bearings though.

How fast does average dead axle go kart go?

It's not welded to tube

Sprocket not spindle sorry lol

I'll get closer pic when I get off ..the bearing had screws but is still stuck but disc and spindle does not. They had pieces of tube to keep everything from sliding. Tubing will spin free but it obstructs me from being able to hit the collars to free them.

The bearings have collar with set screws. I disn't see anything on disc and sprocket. They are welded to a collar that has a key. I'm going to set it up different.

I removed both hubs and one bearing but still one bearing stuck and sprocket and disk. I have been heating spraying and beating for days😖

I had just read this on Briggs site but I use alcohol

What should I use to clean cylinder and head? Like chemicals. Choke cleaner?

So you're saying I need a roster

I haven't cracked it open yet. What's petlock?

WTF the engine block is full of gas!!@$#$% is it bc a valve is stuck

I used transmission fluid and clr for some old chains