Search results

Got it all taken apart and put back together. The drive had some internal damage that my brother in law was able to help me repair and allowed it to fully sink back in and the belt now sets properly which allows the engine to idle and not move when stopped. Thank you everyone for the insight...

Thanks for the heads up. I will get on that.

@Denny should I do a service on the clutch before ordering the comet belt or do you think it will be needed regardless?

So I got the measuring tape out and here is what I know. The old belt was a Manco 6814 and when measured is 33 inches around The current belt on the TC is a Blackhorse which according to the spec is 33 7/8's inches When I check the go kart supply they state the comet belt I need should be 33...

I do not have the old one with me. I will have to check tomorrow and get back with you.

I have a Manco Dingo with a Honda GX390 running a 40 series Comet Torque converter. I recently changed out the belt, carb and pull cord. When I go to start the cart it goes forward when I pull the cord so I think it’s stuck in gear. I am able to start it and it runs fine when lifted on...

Go ahead Bad, I will do what I can to help you with adding information.

Thanks again Grant. I will take good care of it and will enjoy it every chance I get to drive it!

Will be at the swap meet. Hopefully I will have some money than and can maybe buy these.

From looking over that diagram it looks like you might also need a muffler clamp which was mentioned on the second link. It doesn't look like you have a place on the muffler to attach the bolt to.

From one big guy to another I can say that the struggle is real. I'm 6'3" and 250 pounds and was in your position a few months ago. The best option for me turned out to be a Manco Dingo with a 13hp engine. A quick search in your area I was able to find one that might interest you. It's a...

We called the first one and got him down to 1,000. Thanks for all the advice.

Pretty much what I told him I had found out with some short google searches. I thought these I listed below was very nice. http://dallas.craigslist.org/ftw/snw/4688223513.html http://easttexas.craigslist.org/clt/4627811632.html

Well its not for me. A buddy of mine wants me to get some opinions on it. He wants something with suspension, two seats and have lights. He sent me that link as the best thing he could find. I am going to look around and see if I can't find him something else as I don't believe that has a...

Bad deal for 1,000? http://texoma.craigslist.org/bar/4678070946.html

Used to ride near rivers since there are few people to complain. Also road in parking lots of stores that were out of business and were on some very traveled roads. Most go karts are not allowed on city streets because they have no lights or indicators for starters. But a piece of private...

Hey SPC, glad to see a fellow Oklahoman has found the site. I hope the knowledge these fine people have helps your in your project and cant wait to see what it turns into!

My wife's first words after seeing the cart on the trailer "that doesn't look new?". Than began the great joy of explaining what restoration means to your wife.....

I guess I can tell him that multiple people said they would prefer the dingo and warn him about the shocks which I'm sure he wouldn't mind upgrading. He said up to 700. With the Yerf being 400 leaves him plenty of room to upgrade.