Search results

I am considering changing my old Yerf Dog brakes from band/drum style to the mechanical caliper/disk type Thoughts/suggestions Thanks gents ed

I just purchased a new HF Predator to replace my junk Tecumseh The drive end of the Tecumseh crankshaft is 2 7/8 long The Predator drive end is 2.43 long... short by about 5/8 to properly fit the Comet 30 driver Any suggestions Thanks Gents

My Tecumseh OHH 60 71131C is misting fuel out of the carb when I hit the accelerator. Engine hesitates a moment, then seems to increase rpm ok. If I go to about mid throttle & snap it to wide open it will mist fuel out again Adjusted the valves .004 on both - cold The engine starts fine (...

I need to re assemble the gouvenour spring/linkage. The PO made a mess of it all, and I need to start from scratch. Info as follows OHH 60 71131C If I could find a clear drawing , I'd appreciate it I looked at Jacks site, but the dwgs were not clear Tks for your help Ed

The rear wheels on my Yerf dog were seized to the axle so bad that in the process of pulling/heat, the wheel tore apart at the hub. so now I need (1) a replacement Any suggestions to where I might find a reasonably priced replacement. Used would be fine 8 in 1 in keyed bore Tks Gents

Hello Gents, Long lurker/First post... Finally purchased a old Yerf Dog with Tecumseh engine. I knew it was beat when I bought it (150.00) and as usual finding more surprises as I go. Im a pretty good fabricator & engine guy so I can handle most of it Engine: Tecumseh OHH60 71131C disp. 193...

Planning to build a recreational kart for my grandson as a Grandpa Grandson proj. He s 9 yrs old and I m old enough to know better, but still want to play like a kid Just purchased the plans from MXK, primarily because they are local ( about 10 mi). Went to the shop to look around...nice...