Search results

I am considering changing my old Yerf Dog brakes from band/drum style to the mechanical caliper/disk type Thoughts/suggestions Thanks gents ed

Yes. I plan to cut off about 1 inch with saws-all , true it up and bore it on my lathe

Thanks for your response Fabroman. I was hoping for problems to be done with the purchase of the new Predator...not quite i guess I was thinking about cutting off a 5/8 section from the old crank and using it for the spacer what do you think Thanks ed

I just purchased a new HF Predator to replace my junk Tecumseh The drive end of the Tecumseh crankshaft is 2 7/8 long The Predator drive end is 2.43 long... short by about 5/8 to properly fit the Comet 30 driver Any suggestions Thanks Gents

Took it apart, Found the problem Cam was off 1 tooth.... via PO assembled it wrong , or because of the damage I found internally Parts list: intake gasket 1.83 valve cv gskt 4.19 cyl cv gskt 2.02 cam shaft 23.84 needed because end stud chewed...

Russ Good advice! Tks I looked around for a overhaul kit, found a couple on the bay at around $85.00 with a piston /wrist pin. Guess I won t know what I need til its apart My HF flyer showed up today with a Predator 6.5 HP motor listed for 99.00, with the 20% off coupon, gets it down to around...

yea thats what I was thinking Compression test help to diagnose? Is there a way to do a leak down test on this small engine? tks ed

Anyone??

Plug looks ok I can see the mist exiting the carb during the hesitation. I 'll put my hand near the carb inlet, and I can smell a strong gas odor on my hand. to do this the air cleaner is of course off. I was just reading here about the red emulsion tube at the venturi area of the carb. When i...

My Tecumseh OHH 60 71131C is misting fuel out of the carb when I hit the accelerator. Engine hesitates a moment, then seems to increase rpm ok. If I go to about mid throttle & snap it to wide open it will mist fuel out again Adjusted the valves .004 on both - cold The engine starts fine (...

would you have a pic of the correct governor spring? tks ed

Thanks for taking the time to respond Benny, but mine is a different configuration. ed

I need to re assemble the gouvenour spring/linkage. The PO made a mess of it all, and I need to start from scratch. Info as follows OHH 60 71131C If I could find a clear drawing , I'd appreciate it I looked at Jacks site, but the dwgs were not clear Tks for your help Ed

wow!! thats awesome can you direct me to more info about this ? tks

Found/ordered what I needed at BMI Tks Gents ed

NOT welded to the axle... welded to the hub Hub affixed to the axle via key & 2 set screws

firemanjim who do you like to buy from? I will also have to buy a 45T sprocket for #41 chain... had to split the hub to get it off the axle. Sprocket was badly worn anyway. The OE sprocket was a 1 piece steel unit, sprocket welded to the hub Should I find a 1 piece unit ? or go with...

Thanks for the info gran-pann I think the BMI wheel will work out perfect for me. I'm going to hold on placing the order...the sprocket is seized on the axle shaft as well. I'll probably have to cut thru the sprocket and its mounting hub (1 piece unit) in an effort to save the axle. This...

This is what I am looking for ,but 95.00 (56.00 + 40.00 for ship) seems a bit expensive. Thanks for the lead though ed