Search results

Huh

I have done it. The clutch engages too hard for use to propel a vehicle. And when disengaged there it a brake that locks up the clutch. It was only good for burnouts.

Long as you can stand in the drivers seat and jump, and it does not splinter , good work!

Could be flooded. Pull the spark plug, is it wet with fuel or dry? Warning, everyone else will probally say buy a harbor freight engine. Least give the old tecumseh a chance

50$??? Too much I paid 30$ haha They are honda taper, so installing on either predator is not good.

Tomberlin crossfire 150r I had one , gx270 swapped it

all better , no more plywood

Haha it's fine. I need to remount the seat. The manco I got for free with a broken frame. I extended and repaired it, and upsized the rear tires. I just picked up a 99$ predator to replace the built honda, to sell the kart. The sprint kart I have no idea, it does have lifan 212cc with a...

Someone left the whole mower in our junkyard. Had stuff wrapped up in the crank seal. After a cross reference and oreilys trip I got a good engine for free.

I just wanna go fast lol Had em both out today.

Just lawn boys (6.5hp duraforce) and got an 820 to play with Can't help with those parts, but we like pictures

If it helps heres a kart I converted from gy6 to big block - 40 series. The jackshaft makes it easy , factory rear axle sprocket . Plenty of room

I would select 3/4 , it is the most common. If they are supplying the jackshaft, they should ship the corresponding shaft diameter and clutch when ordered. One would hope.

But when you use the nascar edition welder, and mug, you and your vehicles has gots to go faster

I remember Doc on here, I joined in 2011. The main problem with the clone flywheels is the magnet flying off, not the whole thing exploding. But like said, this only happens above 6-7k , when your asking for trouble

I bought a used Lincoln flux core when I was 13yo, for 75$. 15 years later I still use it alot and have put no parts into it other that contact tips and wire. If you can, invest in a used name brand is my opinion. It welds much nicer , can be converted to gas, has replacement parts, ect

Can you do ebay? Seems like international shipping is possible. We need further explanation because you are in a very specific situation here. Ask this seller, racersproquip. Ive bought alot from him...

You will want a steel cam with heavier valve spring installed in the engine. Regardless, the motor won't be making much power at 6500rpm with a stock camshaft, so it may never see it depending on vehicle/ gear ratio

I think a 16x6.50-8 turf saver tire is what basic needs