Recent content by Matts6345

Yeah I am not sure if they need to be there or not. I guess once I get the carb reinstalled and it runs like normal I will just leave them alone.

Good Evening Everyone, I have a Tecumseh HM100-159369P engine on my cart. I was in the process of removing my carburetor to clean and I noticed that the upper spring on the control assembly was fully stretched out I have a starting issue where the go kart will start run for about 5 seconds and...

SO I am thinking about replacing my engine. Just to many issues I don't want to fix. I am currently running a Tecumseh HM100 and I would like to move to something that is more reliable and still 10 Hp. I am not sure about my clutch and what but I basically want to Just be able to take an engine...

Thanks I will try this out tomorrow.

I only had the shroud off. But im not sure about the ignition being properly located I have had issues with clearance so I put it at hits highest setting so that could be my issue.

I have a Tecumseh HM100-159363p I currently had the side cover off to change the ignition relay thingamabob. Now it will crank wont run. If I play with the throttle on top of the carburetor i can get it to run for a few more seconds, But I have absolutely no idle. I think a spring on the...

So this just happened Finally got her to fire up I guess the ignition coil was sitting a little too low I guess my engine is ruined now.

My go kart has some kind of problem. I replaced the battery after a no start issue. OK so battery replaced still no go. in the beginning After new battery I could get it to turn over but not start. Replaced the spark plug and drained the gas and put fresh gas in. Still no go. I changed the...

Hello, I have a basic manual brake caliper set up on my go kart. No matter what I do I cannot seem to find that perfect spot for the brakes they either lock up or do not stop at all or will stop the first couple of stops then have no stopping power at all. I am looking for any pointers on this...

rotors Its hard to tell in the pictures but they are both warped pretty bad.

Rotors I was able to get the hubs off now the rotors are pretty much seized on.

Thanks Guys I will try these out.

OK Thanks how do I remove the nut on the end of the axle. Because even if I hold the other nut on the other side the engine will spins and I cannot get the nut to break loose?

Hello First post here and New go kart owner. I recently bought a go kart and the brakes were trash I ordered new rotors and calipers soon to show up. My issues is getting the old rotors off. I have not a clue everything I have tried so far has been unsuccessful. Any help will be appreciated.