Recent content by James1022

i looked at a comet series 30 TC...is one better than the other?....bmi karts is about a 30 minute drive from my house ,i cant beleive how popular they are online

Ok I found all the torque converter stuff , can you buy a prefab jack shaft plate ready to go?

The motor is mounted right to the frame

It's a 55 tooth sprocket on the axle a ten tooth on the clutch and as far as the chain size I don't know the pitch and all that stuff it's just a bigger chain about like on a Yerf dog 3203

Ok have a question .... My dad just brought home a kart for my boys it's a single seat fox lxt and it has a 6 horse Tecumseh engine with a centrifugal clutch , is this setup right or should it have a jack shaft and torque converter setup? It wants to smoke the clutch now even with a brand new...

Thanks a lot !!

Well I bought a new belt when I first got it and it was tighter than the old belt and now it's very slack , I cleaned the driver clutch and no help , cart still jerks in takeoff , it did this when I first got the cart with the old belt and I put the new on it quit for a few days and then it...

I have a Yerf dog 3203 and was wondering if I could take out the jackshaft plate and have it milled to get a little adjustment is this a good idea ?

The problem is I back it out as far as it will go and it still runs too fast I hooked a spring to pull it back it is kind of jury rigged but it works I just need to find a permanent solution ..... Thanks for the reply

Just bought a 212 cc predator an put it on a little cart I picked up for 30 $ my problem is the engine idles to fast and the clutch engages .... I don't really see any adjustment in the carb .... Any word?

Oh yea one more question , I seen on comets website where I can buy just the innards for the driver clutch for like 30 $ or the whole thing for around 90 what is the best route?

Sweet buy !!

Ok so I cleaned it all up , it was pretty grimy but unfortunately I haven't noticed a lot of difference ( I don't have any dry lube yet) my driven unit is a little rusty I'm going to try to polish it up tomorrow . My bronze bushing slides back and forth leaving 1/4 to 3/8 of the shaft exposed ...

Ok.. I bought my boys a Yerf dog 3203 for 350$ a few weeks ago and the guy I bought it off of told me he had the belt replaced recently , well after two days it quit going , engine running just the drive not engaging right , so I pulled off the cover and the bel was very loose ( I took it off by...

Thank you all for the warm welcome