Recent content by GoTeamWhatEver

thanks for the info.,

took the chain off and put back on, now the clutch is popping when you pull on it. i was on the run so hadn't got to mess with it yet, just wanted to know what the problem was before hand.

ok the keyway runs on both the 1" and 7/8" part,...

im not sure about the keyway yet, ill have to check tomorrow. and the axle is mounted to the frame on the 1" part and i looked for a hub thats 1" to 7/8 step down but cant find any. will reply tomorrow, plz help out if any one has ran across this before and what did you do?

ok got some questions about hubs on rear axle. i have a one inch rear live axle that drops down to seven eighths, and its only two and half inch's long. so if your still following me do i need a one inch hub or a hub that drops down to seven eighths witch i have not seen any where on the web...

put a gx160 head on it help with low end, more compression, and with the gx140 emulsion tube and bigger jet will help. and bore out the carb. your self make more air.

great, i see why about the price difference to. drilled dont work as well so thats why they are so much cheaper, i am going to buy the 90, 92, and 95. just to see witch one works with my setup.

ok ombwarehouse.com has jets for $2.10 on there website, that go by 7mm .028, 9mm .036, to .040. and then affordablegokarts.com has them for $6.00. sizes run from #78, #80, #82, #85, #88, #90, #92, #95, #98. so i ask how do i compare them in size. for instance what would the #92 jet be...

cool deal, also need to know some stuff about jets and emulsion tube. about the jets what size is the #92 jet in mm or decimal. and is the 140 emulsion tube the best one out there or is there more out there.

need to know what parts will fit my 6.5 greyhound motor, think it is a gx200 from what i have read on the net and on here. if any one know some info on this please reply. thanks and i just read i thank lifan makes the motor its just called greyhound... jerremy