Recent content by General Chaos

You can also take a thicker piece, like cereal box cardboard and tap the hole areas with a small ball pein hammer.

Old thread. Look at the date.

His phone number is on the ebay listing. Give him a call and ask.

Yeah, I'm about 6 hours north of Minneapolis so I'm tempted to go but, the amount I'd spend on fuel would make it too costly.

Anyone in the Minneapolis area take note. http://minneapolis.craigslist.org/ank/rvs/2949522700.html http://minneapolis.craigslist.org/ank/rvs/2948406153.html http://minneapolis.craigslist.org/ank/rvs/2908479238.html

Check it out here: http://www.diygokarts.com/speed-calculator.html

Does it work to switch the bearings around, so the thing that sticks out will go to the inside instead of the outside?

Two from scratch and one rebuilt.

Something like this:

The first one will need alot of work. I don't think you can make the first one into the kind of cart the second one is for under $300. Plus the second one has a Honda motor.

I don't know what it would cost from scratch but I know you would save a bunch by buying a used one and fixing it. I bought a used rolling chassis($60) and I supplied a new motor($130), centifugal clutch($50), replaced wheel bearings and drive shaft bearings, driven sprocket and hub, chain($80)...

Thats crazy..... I love it!

How do you get rid of rust on a magneto/coil?

Well, I turned the black screw counter clock-wise again and still nothing. Had to take the filter and cover off of the carb to see why it wasn't working. Seems the spring on the governor linkage was too tight, so the black piece that is supposed to rest against the idle screw wasn't.

I think its already sold.