Recent content by Dieselchanic

Just a tip... If you've never done this before and it doesn't take the first time, use way less ether on the second try. The air and gas inside the tire is hot from the first go and makes the next explosion much more volatile. We do this on truck tires all the time and I watched one brilliant...

You can buy that stuff on eBay used as cheap as steel... Actually waay cheaper than dom steel. I wouldn't use it either, but I build my own stuff.

I'm not sure it would hold up to a gokart frame but there's this? http://www.dyna-frame.com/

Might wanna turn that motor around unless you plan on backing up.. I turbo'd a flathead Briggs but I think the turbo was too big. It would spool it up but I doubt it actually built any manifold pressure.

Ya ya I know... Gotta get this beast off the table first..

Wow. That's quite ambitious for a first project.. Hope it works for you and good luck. Welcome to the site.

I'm going to give him the benefit of the doubt and chalk it up to a bad translating program... I hope. Welcome anyways.. Sometimes life is boring.

Well you could mount your motor a little higher then run a belt or chain down to the drive shaft giving you gearing options. Otherwise, you'd have to run a Lovejoy coupling anyways so the cost would possibly be close to the same either way. On the other hand, I don't know much about what I'm...

Because I had three projects at the time along with two customer bikes and I felt a little overwhelmed. Posted it up on craigslist for a high price and someone bought it... It wasn't even finished, just lacked paint...

Ya the list gets long. I just sold my xs650 brat so I've been thrashing on getting my next build on the road so I have something to ride.. It's still o long ways looks like.

You guys would have to understand 'me' a little better to fully comprehend the situation. I'm not saying your suggestions aren't useful, knowledgeable, and no doubt the best course of action. I just tend to be, well... different. My hobby is building motorcycles. Hardtail, barebones, out of the...

That's a really neat looking kart and from what you described it will look awesome when finished! Nice to see a fellow bike builder around too. Wouldn't mind seeing some pics of those projects too sometime...

Nice build! I love to see projects that come to life from the ground up. I built a mini chopper to learn to weld 11 years ago and it was a great experience. The only problem I see, and I don't know if it's a problem because I tend to over engineer stuff, is the front axle where the angle is...

Because it's junk. The whole frame is total junk. If it moves it wears out extremely quick. It will ride way better rigid than it would before and suspension wouldn't help that much on something this small anyway. Almost all mini bikes are rigid... Plus, I'm just killing time and building this...

I cut the ends off the stock shocks and welded in 5/8" solid bar to make struts. It's sits nice and low now but I need to adjust the camber.