Recent content by Britcom61

My rim has "8x7.00 G.B.C. 1008" stamped on it, the tire size is 18x8.50-8. Would this be the correct rim? I found this at BMI 8" Rim w/1" Bore (260081) This is an 8" rim 1" Bore with 1/4" Keyway Rim is 7" wide

My 32001 has the rear wheel rim coming appart from the hub, it is an 8x7 size wheel with 18x8.5x8 size tire. I just need the rim, have looked online at tractor supply, Northern Tool etc but have had no luck. Anyone know where I can get a replacement? Help would be greatly appreciated....

Fixed

It turned out that the wrong belt was installed, then the governor would slow me dow every time I got near top speed. I ended up loosening the governor arm, drilling a 1/8" hole through the shaft and installing a washer and split pin so the arm would not slide off. Hence I disconnected the...

I just purchased a replacement belt for my kart on eBay, the model I am replacing is a Gates Powerlink 743-20. Just received the belt but it is a symmetrical cross section and mine as asymmetrical. None of the belt descriptions seem to mention this distinction. So if anyone knows where I can...

Looking forward to some photos Regul8R, Im not sure about the jack shaft that was mentioned earlier by Gokarts4Life-11! Does that mean I cant use the one thats on there at the moment? What did you do about that problem? I have become frustrated when Im trying to start out on an incline, the 6hp...

Your Predator install I would be interested in finding out what the measurements are for the mounting holes, just to see if I can fit this motor on the mounting plate without adding a larger one. I also checked out the link for the TC but it said "out of stock, do not order". Any photos you...

Got the cash for the engine, don't known what type of clutch to use though, my setup now has a comet clutch with belt drive to the small sproket that drives the rear axle. Any ideas about the best clutch setup would be appreciated, thanks.

Hi, does anyone have experience with this Predator 420 from Harbor Freight, says it has electric start, that would be a plus for me. I am looking to replace my Tecumseh 6hp, this motor is about twice the displacement so I would definitely get the extra power I'm looking for. I ride mainly...

Just need info on main spring Thanks for including a link, that's the same one I found online and used to order the parts I needed. The main spring that pulls the throttle open has a hook that connects to the bottom of the governor arm, there is a loop in the middle that I have booked up...

The engine Model is OHH6O-71131D (E) Engine Family is YTPXS 1951 AB Hope this is what you need, a diagram would be really helpfull, thanks, Lee.

Hi All, I just received the springs and governor conectors for my Yerf Dog with a 6hp Tecunseh motor, just cannot figure out how these parts go together. I know they should work as I ordered them from a parts diagram and they look right compared to the parts that were there before becoming LOST...

Hi Guys, I was working on my Tecumseh throttle lincage and governer system. I remover the spring, and the other 2 linkages together with the air filter box. Working on the grass outside my barn. I had not re-assembled any parts as it got too dark, so I left the parts on the ledge at the back of...

Already done, lubed it with Dry Graphite Spray, cleaned the two surfaces on a bench grinder on wire wheel side. Not sure if I can do the same on the driven side? I have not tried to take it appart to clean the surfaces.

I have a tecumseh 6hp and have got the motor running pretty good but have a problem on my take off. It has a comet TC with the belt system going to a driven side with a chain drive. I did tighten the chain by sliding the motor back a little and think it might be a little too tight, would that...