Please Help with Tecumseh Governor Setup

[Britcom61]

Hi All, I just received the springs and governor conectors for my Yerf Dog with a 6hp Tecunseh motor, just cannot figure out how these parts go together. I know they should work as I ordered them from a parts diagram and they look right compared to the parts that were there before becoming LOST.
Anyway, if anyone has a photograph or diagram, or link to either! I would really appreciate the information, thanks for the help, Lee in VA.

 

[Enduro Karter]

I can get a diagram for you Lee, just need the model and type number off of the engine. The numbers should be on the blower housing.

 

[Russ2251]

"L" head or "I" head?

 

[Britcom61]

The engine Model is OHH6O-71131D (E)
Engine Family is YTPXS 1951 AB Hope this is what you need, a diagram would be really helpfull, thanks, Lee.

 

[the-cyborg]

post some pictures of your engine from all sides at different angles.
I found a parts breakdown for the OHH60, but setup varies within the models.

http://www.outdoordistributors.com/pdf/Tecumseh/TECUMSEH-MODEL-OHH60-71131D-PARTS-LIST.pdf

 

[Britcom61]

Just need info on main spring

Thanks for including a link, that's the same one I found online and used to order the parts I needed. The main spring that pulls the throttle open has a hook that connects to the bottom of the governor arm, there is a loop in the middle that I have booked up correct, just can't figure out where the end of the Spring. Get is supposed to go? If I can take photos that close, I will show you my dilemma, Thanks for your help so far, Lee