Kartdude2000
New member
- Messages
- 26
- Reaction score
- 0
I have an old yerfdog and am going to put in a new predator, cvt etc.
Any suggestions on where to buy everything to do this? I did the same thing YEARS ago but haven’t thought about it since.
The 2 issues I ran into last time were 1) the bolt the attached the cvt to the driveshaft BARELY went into the driveshaft. Like maybe 1/2”. Not much depth there. Didn’t cause an issue necessary but I remember not liking it...
2) after a year or so the kart would run but under load wouldn’t move. Engine was fine but I could never figure out wth was wrong.
Any advice would be helpful to complete the rebuild and ensure I don’t have the same issues. Thanks!!
Sent from my iPhone using Tapatalk
Any suggestions on where to buy everything to do this? I did the same thing YEARS ago but haven’t thought about it since.
The 2 issues I ran into last time were 1) the bolt the attached the cvt to the driveshaft BARELY went into the driveshaft. Like maybe 1/2”. Not much depth there. Didn’t cause an issue necessary but I remember not liking it...
2) after a year or so the kart would run but under load wouldn’t move. Engine was fine but I could never figure out wth was wrong.
Any advice would be helpful to complete the rebuild and ensure I don’t have the same issues. Thanks!!
Sent from my iPhone using Tapatalk