Yerf dog 3203 sprocket will not line up with the 9 tooth sprocket

[Meiko]

Hi guys. I bought a yerf dog 3203 go cart today but the chain broke on it because the big sprocket isn't lined up wit the smaller one. I'm not a machanic but I can do some things but I have tried wd40 and Reyes soaking it and even beating on it to move it over, how can I get it over an inch? It's not welded so I don't k now what to do

 

[OzFab]

Did you loosen the grub screws/locking bolts?

Throw up a pic or two so we can see what's going on

 

[landuse]

Yeah, throw up a pic. You will usually have a few grub screws that nee to be loosened as well. It could have rusted a bit as well. Apply some heat to the sprocket hub and then throw some cold water over it. The shock can break the rust seal if there is one

 

[Meiko]

Did you loosen the grub screws/locking bolts?

Throw up a pic or two so we can see what's going on

I took the two bolts that kept it " on " there, I will have to take a better pic tomorrow, I have one from a foot away doesnt show anything but il update it tomorrow.

 

[Nodroz]

Yeah.. we can't do much with that picture.

It would be good if we can see the sprocket itself sitting on the axle. Is the axle and / or sprocket rusty? If so, try what Landuse said. ^^