WOT issue with 79cc Predator engine

Status
Not open for further replies.

alwaysinboost

New member
Messages
8
Reaction score
0
I put a new predator engine in my sons kart a few weeks ago. we got all the bugs worked out and slowly he's getting used to the power. He is at the point where he can hold WOT all the time and still control the kart, so I figured he's about ready for more power.

Problem is I can't get the motor to stay WOT.

WHen you push the gas pedal all the way down, the motor will rev up like its going to make full power, then it will fall back slightly, then rev up again. it keeps doing this the whole time your foot is to the floor. I made a video to show what is happening with the linkage.

https://youtu.be/4laTPYA-TiE

In the vid you can see the throttle linkage slowly moving and you can hear the RPM increase. The linkage closest to the camera is the throttle cable and the straight bar that is moving back and forth above the throttle linkage is where the problem is. That bar is moving all on its own.

I am sure it has something to do with how the linkage is setup or how the carb is setup. Hopefully this is descriptive enough and someone more knowledgeable than myself can narrow it down. TIA.
 

DHC

New member
Messages
111
Reaction score
4
That would be the governor feathering the throttle. n keeping the rpms at ~3600. The thin spring that is under the tank, closest to the arm pivot, can be 'adjusted' to minimize the fluctuations. Relocate the spring connection on the arm, to closer to the pivot (I think... could be the other way?!?).


EDIT:
Just realized ur engine... its alil different setup that the engine I was thinking... the all the same... it 'should' have a spring (maybe under the tank) that'll have control of the amount of feathering the engine does at WoT.
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
I never had that problem with either of my 79cc. and I did move the throttle spring to get more throttle.
 

alwaysinboost

New member
Messages
8
Reaction score
0
is this "hunting" though, or is it a governor issue?

I pulled the plug this weekend to air the CC out because it was flooded from trying to start. Plug looked fine. no signs of running lean that I can tell.
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
is this "hunting" though, or is it a governor issue?

Yes, it's extreme hunting...

I pulled the plug this weekend to air the CC out because it was flooded from trying to start. Plug looked fine. no signs of running lean that I can tell.

Sorry for asking (I'm unaware of your knowledge & experience) but, do you know what you're looking for?
 

alwaysinboost

New member
Messages
8
Reaction score
0
I'm not an expert in reading plugs, but I know a little bit about what to look for.

I don't think this issue is fuel related, or "hunting" as you call it. If you watch the video, the RPM fluctuation is very rhythmic. It doesn't seem at all like a fuel delivery issue. Also, the motor is brand new (only a couple hrs total on it) and I am using premium fuel.

I think this is a governor issue, like mentioned before.
 
Status
Not open for further replies.
Top