Many flatties were aluminum bore. Only the I/C versions and the Raptor were cast iron. So where's the quality there? ALL clones are cast iron bore and dual ball bearing crank.
Can you not gain hp with a clone by adding a header/filter/jet? I'd have to say that thousands of clone kart racers out there think they are worth it. A clone with the very simplest racing mods are DESTROYING fully blueprinted Briggs Flatties every week on the racetrack. They have to put a restrictor plate on the clone or move the stock clones up to run with the high dollar flatties running restricted to even compare them.
Just because its been around for years and still runs doesn't make it a better engineered design than something i can buy new today and take care of and get more power out of cheaper than a flathead.
Can you not gain hp with a clone by adding a header/filter/jet? I'd have to say that thousands of clone kart racers out there think they are worth it. A clone with the very simplest racing mods are DESTROYING fully blueprinted Briggs Flatties every week on the racetrack. They have to put a restrictor plate on the clone or move the stock clones up to run with the high dollar flatties running restricted to even compare them.
Just because its been around for years and still runs doesn't make it a better engineered design than something i can buy new today and take care of and get more power out of cheaper than a flathead.