ML-TOYS
New member
i am curious
the vid
http://s243.photobucket.com/albums/...rrent=2012-09-22_17-56-52_287_zps2d0a001c.mp4
the vid
http://s243.photobucket.com/albums/...rrent=2012-09-22_17-56-52_287_zps2d0a001c.mp4
That is a pneumatic (air vane) governor. It is an alternate method to the mechanical (centrifugal) governors we usually have.
So it gets blown back, preventing the the engine from revving too high?
Your accelerator is working through the gov linkage, just as if it were setup for a tiller, generator, lawnmower, etc.So, with your foot firmly planted on the accelerator, how does the governor do it's job?
I didn't say that.Russ you said disconnect it
I didn't say that.
Disconnect is not necessary.
I would just leave it where it is. Air flow will not be affected regardless of position of air vane.
As previously stated, cable can be directly connected to butterfly and will overpower gov with NO ill effect.
Your accelerator is working through the gov linkage, just as if it were setup for a tiller, generator, lawnmower, etc.
No matter how hard you step on pedal, rpm will not exceed set rpm (~3600).
By-passing gov is quite easy. Directly connect accelerator linkage to butterfly. This will override anything the gov wants to do. Springs associated are exceedingly weak.