what size clutch

Status
Not open for further replies.

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Just re-read the first post. He states that's it's an electric start. Seems like we both missed that part. :roflol:

Even better; just crank it & watch the shaft "D

I agree. If you're going for a centrifugal clutch, a jackshaft will be necessary.
To fabroman: will he also need a such a high ratio when using a torque convertor?

Yes. if he's using a jackshaft without a cvt; it will just be a mess of sprockets & chains if he does use a cvt
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
To calculate the gearing on a jackshaft (with a centrifugal clutch), you use this equation:

(JS in/Clutch)*(axle/JS out)

For example

16T clutch
36T JS in
14T JS out
57T axle

(36/16)*(57/14) = 2.25*4.07 = 9.16:1

To get the gearing you are looking for, you just play around with tooth counts until you get a combination that works for you. You need to know what sprocket tooth counts are available first though.
 

manco415

New member
Messages
11
Reaction score
0
if i ware you id go to a tc and have the most out of the power you have and for chain id go with something around the 40 mark because 35 chain will cause lots of trouble with all the power you have
 
Status
Not open for further replies.
Top