what kind of 2 cycle is this?

[847]

i'll get pics up when my cam works

on the carb is says "w18a" under that it says "54". on the bottom it says"zama" from what i can tell it's a c1u. but that means nothing as i dunno what it goes to.

on the engine it says 3453 lot c, then over more it says 530-012581 rev b. and on the casting by the intake it says 12519.

the flywheel says 15-567 "walbro "

the coil says 545-024901 then below that it says ma-73 1235 "walbro"

and the plug is a rcj6y

 

[Russ2251]

The cheap kind.
25cc Poulan Weedeater

 

[Kenny_McCormic]

The cheap kind.
25cc Poulan Weedeater

They are cheap but they can take serious abuse.

 

[847]

well, can i upgrade it? i have a walbro wt-312 carb ... not sure how good that is. but yea, it's way bigger, diameter wise. can i put the regular x-tube on it? was also wondering if my stock carb would take a volocety stack, or if the 312 worked, if i could find a stack for that.

 

[Kenny_McCormic]

Your not gonna find performance parts for a weadeater, run it without the muffler and put a bigger air filter on it. maybe port it out.

 

[847]

well, i figured the spacing would be around the same for the x-port. but if not, yea putting a hole in the muffler. goin' to try out tomorrow or in a few days about the walbro carb. i think i may need some ether for this one tried it tonight, seems to flood the crap out of the cylinder.

 

[Kenny_McCormic]

well, i figured the spacing would be around the same for the x-port. but if not, yea putting a hole in the muffler. goin' to try out tomorrow or in a few days about the walbro carb. i think i may need some ether for this one tried it tonight, seems to flood the crap out of the cylinder.

Sounds over carbed, probably gonna need adjustment.

 

[847]

can you reccomend? also which way is correct for ignition? i tried clock wise and counter clock wise... got a few pops on counter clock wise .. i think? how many turns in on high and low needle? thanx

also, clock wise, the muffler was on the left, using forward on a drill, counter clockwise was reverse on the drill.

 

[847]

also where can i get the rear sprocket that bolts onto the bikes back tire? does it need an adapter?

edit -

you really think a x port won't work?

http://www.gomeyer.com/rc-cars-scooters/tgn-xport-lg-p-204.html

it has 23-29cc engines listed .. what's the diff? the bolt pattern/width?