What Clutch to Use?

[bob58o]

I say go for the 3/4".
I think KartFab has a 40 series TC on a big block with a 5/8" jackshaft.

Maybe I missed something, but for a TC system with a 1" driver and 1" driven I think it is going to cost you more than 60 or 70 extra $$$. I was thinking hundreds and hundreds of $$$.

Show me the links of what you were thinking of using.

---------- Post added at 09:33 PM ---------- Previous post was at 09:27 PM ----------

As J-405 pointed out. A 1" Jackshaft needs a 90D driven unit...For use with 94C, 780, 770 Series and others requiring 1-3/16” TW Belt.

About $400 with no belt, as far as I can tell.

 

[ChuckChapman]

New and confused

Hey I’m just new to forum stuff and I have been following along a bit. I have a 14hp engine with a 1 1/8 output shaft and can’t locate a clutch. Is it possible to put a centrifugal clutch on the driveshaft rather than the output shaft?

 

[mckutzy]

Hello and welcome..chuck
You will need to start your own new thread.. and ask there...

 

[Slabach]

ok, i'll just have to spend the extra bucks to get the good tc then...
Btw, (This is not about TCs) The steering of this go-kart is going bad and I need to completely redo it. Got any suggestions? Also, the paint is peeling so I need t get it off, but I don't know of any way other than to just grind the whole thing (blah!). I don't have a sand blaster. And I need to repaint it with something that won't peel like the existing paint.

 

[Slabach]

This is what I am thinking of using:
https://www.ebay.com/itm/332553785775
OK, so I will try again to add pics to the thread: As I said earlier, its a major project!

 

[Slabach]

Try this