torque converter question

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
so im planning on getting the torque converter for my baja when i get the cash, ive heard that it basically disables the governor. I heard the load from the torque converter disables the governor but keeps it around 3500 ish rpm, is this true? What speeds am i looking at from a stock baja heat with a torque converter? Also, when i took out the throttle stop screw on this motor it was very unsteady and full throttle, it acted like it had a burst rpm and it wouldn't stay constant, it would basically surge, but if i let up on the throttle a little bit it went just fine, is this an engine problem?and also, after about 15 seconds of running, the exaughst starts to smell like its burning, its oxidized a little bit, but is the smell normal?
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
it acted like it had a burst rpm and it wouldn't stay constant, it would basically surge, but if i let up on the throttle a little bit it went just fine, is this an engine problem

I believe that is the govenor kicking in...
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
when the governor kicks in with the screw in, it recudes to a steady ride and speed, when i took out the throttle stop screw, it like gave me a burst of rpm every other second
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
but its only with it full throttle, if i reduce a bit it goes niec and smooth, but full throttle it goes fine, gives an extra rpm kick, then drops back to normal
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
guess its just factory, i kept my stop screw out a little more than factory, and it did this, put the screw back in to where it seemed to be, and as long as keep my throttle position steady im good, like if i want to stay full throttle, i have to make sure, i hold it at full throttle, if i only want half, only hold half, guess my carb just wasnt turned for the full amount of revs
 
Status
Not open for further replies.
Top