GoKartNarc
Maintained Machine
Hi everyone,
So I have a 420cc on a Manco Dingo frame. I bought the torque converter from Go Power Sports. The problem is with the bearing for the jack shaft closest to the torque converter. The original bearing had disintegrated and fell apart cause something was rubbing, but I fixed that already. So I ordered new bearings specifically for go- karts and a new jack shaft for the torque converter. I installed the new bearings and shaft and then took it out for a ride, probably about 15 minutes worth and when I got back to my garage I noticed the bearing closest to the torque converter had disintegrated again. Not sure why this is happening. Everything seems to be lined up properly in the back. Chain isn't too tight or loose. Any suggestions.
Thanx,
GoKartNarc
So I have a 420cc on a Manco Dingo frame. I bought the torque converter from Go Power Sports. The problem is with the bearing for the jack shaft closest to the torque converter. The original bearing had disintegrated and fell apart cause something was rubbing, but I fixed that already. So I ordered new bearings specifically for go- karts and a new jack shaft for the torque converter. I installed the new bearings and shaft and then took it out for a ride, probably about 15 minutes worth and when I got back to my garage I noticed the bearing closest to the torque converter had disintegrated again. Not sure why this is happening. Everything seems to be lined up properly in the back. Chain isn't too tight or loose. Any suggestions.
Thanx,
GoKartNarc