Regul8R
New member
Hello,
I have never used a torque converter before. I have a brand new G4 Driver and Driven on my go kart: http://gokartsupply.com/4044seri.htm (The engine is a Predator 420cc) I was able to test it out for the first time this weekend.
The engine idles just fine with the torque converter system on. I can start to drive the kart, accelerate, and slow down just fine. But when I try to bring the kart to a full stop, 95% of the time the driver does not fully disengage (the driver unit is still grabbing the belt), thus it stalls the engine. I have to tap the plate on the driver to get it back into its fully disengaged position.
Is this typical with a new driver unit and it just needs to go through a break in period? Or do I need to return the Driver unit and get a replacement?
Any tips, tricks, or advice is very much appriciated, Thank you.
I have never used a torque converter before. I have a brand new G4 Driver and Driven on my go kart: http://gokartsupply.com/4044seri.htm (The engine is a Predator 420cc) I was able to test it out for the first time this weekend.
The engine idles just fine with the torque converter system on. I can start to drive the kart, accelerate, and slow down just fine. But when I try to bring the kart to a full stop, 95% of the time the driver does not fully disengage (the driver unit is still grabbing the belt), thus it stalls the engine. I have to tap the plate on the driver to get it back into its fully disengaged position.
Is this typical with a new driver unit and it just needs to go through a break in period? Or do I need to return the Driver unit and get a replacement?
Any tips, tricks, or advice is very much appriciated, Thank you.