Torque Converter, Driver Not Fully Disengaging

Status
Not open for further replies.

Regul8R

New member
Messages
14
Reaction score
0
Location
Houston, Texas
Hello,

I have never used a torque converter before. I have a brand new G4 Driver and Driven on my go kart: http://gokartsupply.com/4044seri.htm (The engine is a Predator 420cc) I was able to test it out for the first time this weekend.

The engine idles just fine with the torque converter system on. I can start to drive the kart, accelerate, and slow down just fine. But when I try to bring the kart to a full stop, 95% of the time the driver does not fully disengage (the driver unit is still grabbing the belt), thus it stalls the engine. I have to tap the plate on the driver to get it back into its fully disengaged position.

Is this typical with a new driver unit and it just needs to go through a break in period? Or do I need to return the Driver unit and get a replacement?

Any tips, tricks, or advice is very much appriciated, Thank you.
 

B man

Tecumseh FTW!
Messages
2,490
Reaction score
3
Location
Oliver springs,Tn
my driver does the same. mine does it because of a bad weight assembly in the driver. maybe your weights messed up.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
Lube the clutch.

Lube the clutch? You don't need to lubricate a brand new torque converter, and you never use anything but dry lubricant. DO NOT LUBE IT. It should not do that right out of the box. Something is definitely wrong. I'd send it back and day yours is defective.
 

Regul8R

New member
Messages
14
Reaction score
0
Location
Houston, Texas
Bighead, Yes it is brand new. UPS dropped it off on Friday, I took it out of the box and installed it Saturday morning. I just didn't get a chance to test it until Monday morning (July 4th).
 
Status
Not open for further replies.
Top