My belt broke and jammed in the driven unit. I thought it was just a broken belt and replaced the belt. When I put the ne belt on, the belt didn't engage when I pressed the gas.
When I investigated the problem, the belt had "too much space" in the driven unit. I removed the driven unit and inspected closer. The spring in the driven unit is loose (spins freely). It looks like the tail of the spring needs pushed back down in a hole. There are three holes labelled 1, 2, and 3 and I'm not sure which one to put it in.
Also, on the inner side of the driven unit there are little plactic caps over the tabs that extend and touch the tabs of the other half of the driven unit. All three of these plastic caps are now missing. They must have been knocked loose when the belt broke because I remember them being there before. Can i purchase just these little caps?
Thanks for the help!
When I investigated the problem, the belt had "too much space" in the driven unit. I removed the driven unit and inspected closer. The spring in the driven unit is loose (spins freely). It looks like the tail of the spring needs pushed back down in a hole. There are three holes labelled 1, 2, and 3 and I'm not sure which one to put it in.
Also, on the inner side of the driven unit there are little plactic caps over the tabs that extend and touch the tabs of the other half of the driven unit. All three of these plastic caps are now missing. They must have been knocked loose when the belt broke because I remember them being there before. Can i purchase just these little caps?
Thanks for the help!