chin_lee
New member
OK something happened and my previous post was accidentally removed.
I'm a 42 year old noob to gokarts but I am mechanically inclined. I am hoping to get some good advice and opinions on my options.
I bought a project Murray go-kart to work with my son. It currently has a Powerfist 6.5hp engine. I was looking at the clutch, engine and sprocket and it was about 1/4 to 1/2 inch off. I removed the wheel/sprocket/brake assembly and determined it will be easier to adjust the clutch rather than modifying the frame. I removed the outer clutch cover and the inner assembly leaving behind the center part of the clutch on the engine bore.
Here is the picture of the outer assembly.
Here are pics of the inside clutch assembly
Should I be replacing this clutch? I am not familiar with how much wear is on the clutch.
Here is some pics of the center piece on the bore.
Here is pic of one of the holes to secure the clutch to bore. I don't believe the previous owners put the bolt in there.
Here is a pic of the other hole.
Here is a straight shot of the bore.
Is there suppose to be a bolt on this?
So my other questions:
Should I replace the clutch?
If so, should I just angle grind that center piece off? I tried getting that piece to come off and its not budging at all.
If i do angle grind it off, I do grind off that shiny smooth metal piece as well?
Any advice, help and opinions will be greatly appreciated.
Thanks
I'm a 42 year old noob to gokarts but I am mechanically inclined. I am hoping to get some good advice and opinions on my options.
I bought a project Murray go-kart to work with my son. It currently has a Powerfist 6.5hp engine. I was looking at the clutch, engine and sprocket and it was about 1/4 to 1/2 inch off. I removed the wheel/sprocket/brake assembly and determined it will be easier to adjust the clutch rather than modifying the frame. I removed the outer clutch cover and the inner assembly leaving behind the center part of the clutch on the engine bore.
Here is the picture of the outer assembly.
Here are pics of the inside clutch assembly
Should I be replacing this clutch? I am not familiar with how much wear is on the clutch.
Here is some pics of the center piece on the bore.
Here is pic of one of the holes to secure the clutch to bore. I don't believe the previous owners put the bolt in there.
Here is a pic of the other hole.
Here is a straight shot of the bore.
Is there suppose to be a bolt on this?
So my other questions:
Should I replace the clutch?
If so, should I just angle grind that center piece off? I tried getting that piece to come off and its not budging at all.
If i do angle grind it off, I do grind off that shiny smooth metal piece as well?
Any advice, help and opinions will be greatly appreciated.
Thanks