TKM Engine BT82 Flooding problem

Status
Not open for further replies.

TKM_Owner

New member
Messages
55
Reaction score
0
Location
Wigan, UK
ran my kart today and it keeps letting in a hell of a load of fuel
into the carb now theres a mixture screw and a air screw on the side of the carb and i dont know how to set them right can someone help me and point me in the right direction please.
Thankyou
 

Attachments

  • DSCF1474.jpg
    DSCF1474.jpg
    99.7 KB · Views: 10

sexyvicta

New member
Messages
806
Reaction score
2
its quite hard to get it right on these direct drive racing karts while driving around a carpark:D. Me and my friend were having problems with the kt100 in the carpark the other week. We found about 1.5-2 turns on the low speed and about a 1/4 turn or maybe a bit less on the high speed was good to get it going. You'll have to keep adjusting as you're driving it to get it right. Richen or lean off the high speed as necessary when you get up to temp and speed. If it hesitates on acceleration richen up the low speed(edit: but i think you have to lean it off a bit once its started and starts to warm up). Probably easier on a track where you can run at wot for more than half a second lol

dunno if kt100 walbro is anything like what you have. Maybe have a read on a racing kart forum or talk to a local racer

edit: from the internet, talking about formula tkm:

4.2.2 Initial settings
Turn both jets in until lightly seated. Turn the High jet out to 1/3 turn on cold days, 1/2 turn on hot days.

Turn the Low jet out 11/4 turns on cool days and 11/2 turns on hot days.

4.2.3 Jet Adjustment
The engine should run OK with these initial settings, but will require tuning to achieve best performance.

Note that if the mixture is too weak it can result in damage to the engine.

• If the engine smokes and four-strokes at corners then the mixture is too rich. Weaken the mixture by closing the low and high jets together in increments of 1/16 of a turn.

• If it is slower than others along the straight because it won’t rev high enough (i.e. It flattens out at below 15000 and sounds ‘fluffy’) then it is too rich at the high end. Weaken the mixture by closing the high jet in increments of 1/16 of a turn. If the track temperature is high then turn the low jet out by equal amounts.

• If the top end fades or pops and spits then the mixture is too weak. Open the high jet in increments of 1/8 of a turn.

• If it has poor pulling at low revs coming out of corners, but no engine smoke is visible. The mixture is too weak at the low end. Open the low jet in increments of 1/8 of a turn.
 

sexyvicta

New member
Messages
806
Reaction score
2
what do you mean?

usualy has an L and an H stamped onto the carb indicating which screw is which
 

TKM_Owner

New member
Messages
55
Reaction score
0
Location
Wigan, UK
theres nothing stamped on theres a screw on the right towards the seat aand the left one as you can see on the picture
 
Status
Not open for further replies.
Top