KartFab
Active member
so, whats up with this timing stuff. I am constantly hearing, 'advance by 6-12 degrees' blah blah and im trying to get the concept down
so TDC is when piston is highest, ok got that
BTDC is what the timing is set to, so degrees before top dead center
these little stock engines have about 25 degrees before top dead center as their timing, and you need to advance that to whatever to continue to make power at higher rpms.... ok understandable
i hear the standard ok so 6-8ish is good for most mild cams, check..... so advance to 31ish-33ish.
got a piston stop on the way, degree wheel i already have, timing light on the way, yes it woudl be easier to just get an offset key and be done with it, but I want it to be exact....
but i still dont get why it is that 'advancing' the timing is actually making the spark occur later... because TDC is when everything is getting compressed, right? so spark happens BEFORE that, at 25 degrees, so if you set it to 30+ degrees before top dead center, the spark is actually happening LATER compared to 25 degrees, and compared to top dead center... now im all confused, because I was under the impression that
1) it takes a certain amount of time for the flame to propogate
2) 'advancing' the timing helps start the flame sooner, to make up for the smaller time it has to burn in that cycle
now knowing that 'advancing' the timing, is just making it happen LATER?!?!?! compared to TDC.
I need some esplainin'
so TDC is when piston is highest, ok got that
BTDC is what the timing is set to, so degrees before top dead center
these little stock engines have about 25 degrees before top dead center as their timing, and you need to advance that to whatever to continue to make power at higher rpms.... ok understandable
i hear the standard ok so 6-8ish is good for most mild cams, check..... so advance to 31ish-33ish.
got a piston stop on the way, degree wheel i already have, timing light on the way, yes it woudl be easier to just get an offset key and be done with it, but I want it to be exact....
but i still dont get why it is that 'advancing' the timing is actually making the spark occur later... because TDC is when everything is getting compressed, right? so spark happens BEFORE that, at 25 degrees, so if you set it to 30+ degrees before top dead center, the spark is actually happening LATER compared to 25 degrees, and compared to top dead center... now im all confused, because I was under the impression that
1) it takes a certain amount of time for the flame to propogate
2) 'advancing' the timing helps start the flame sooner, to make up for the smaller time it has to burn in that cycle
now knowing that 'advancing' the timing, is just making it happen LATER?!?!?! compared to TDC.
I need some esplainin'